Andino Pico2Pi
Description
Andino Pico2Pi, Pico RP2040 in the form factor of the Raspberry Pi 4
Use
Wherever high precision signal acquisition is required, a microcontroller without an operating system is an advantage.
This is where the Pico2Pi comes into play. It can be used in the devices of the Andino family as a replacement for the Raspberry Pi 4 / CM4. The access to the IOs (inputs, relay, RTC, SPI-UART, CAN bus) can then be done by means of the RP2040 controller with real-time processing.
Although the Pico2Pi does not offer network interfaces like the Pi4, it can be integrated using an isolated RS485 as e.g. Modbus RTU.
The Andino Pico2Pi can be used with the Andino world via the normal pin connector (2x20). It can be combined with the following products:
All features or IO of the individual devices are addressable with the Pico2Pi (except 4G).
The Pico2Pi has the same form factor as the classic Raspberry designs. Therefore it can be used in the same housings. In addition to this, a galvanically isolated RS485 interface is available as standard. So it is possible to program a Modbus RTU (Remote Terminal Unit).
Product specifications
The module consists of an adapter with a soldered Raspberry Pico!
More information can be found on our documentation page for the Pic2Pi
- RP2040 microcontroller
- Dual-core Arm Cortex-M0+ processor(up to 133 MHz)
- 2 × UART, 2 × SPI controller, 2 × I2C controller, 16 × PWM channel
- 26 GPIO pins, including 3 analog inputs
- Isolated RS485 interface for e.g. Modbus RTU
- Raspberry Pi compatible form factor (2x20 GPIO)
The module consists of an adapter with a soldered Raspberry Pico!
You can find more information on our Pic2Pi documentation page