• Till 01/2020 we only ship with Raspberry Pi 4 1GB
  • Shipping within 24 hours of order!
  • Our customer service will gladly answer your questions about our products. Mon - Fri 8:00 - 17:00
  • We are here for you! 0049 09197 235323-5
  • Till 01/2020 we only ship with Raspberry Pi 4 1GB
  • Shipping within 24 hours of order!
  • Our customer service will gladly answer your questions about our products. Mon - Fri 8:00 - 17:00
  • We are here for you! 0049 09197 235323-5

Andino X1 with Raspberry Pi 3 B+, dual Channel RS232, Heatsink and RTC

170.00 €

incl. VAT plus delivery
Delivery time: 1-2 day(s)

Description

Raspberry Pi extension with integrated two Channel RS232 interface

The Andino X1 is a microcontroller board in a rail mounting (TS35) housing.
It is used to adapt digital inputs and outputs for a maximum voltage of 24 V.
The X1 has its own microcontroller for signal preprocessing and adaptation of signal generators and actuators. Optionally, a Raspberry Pi (Model B) computer board can be inserted.
Communication between the microcontroller and the Pi takes place via the UART interface.

The Andino X1 offers the following advantages:

  • Provides mounting on a DIN Rail / mounting Rail (TS35) for installation in manifolds.
  • It provides an industrial power supply for the Raspberry Pi.
  • Two isolated (5kV) digital Inputs for 24 Volt
  • Two Relay outputs (24V, 1 Ampere)
  • Two Channel RS232 (Rx,Tx).

The 8-bit microcontroller has an Arduino-compatible bootloader and is ideal for sensor and logic tasks.
Its simple programming allows for faster development cycles and saves prototyping costs.
The X1 board has two electrically isolated inputs (up to 5kV isolated) and two relay outputs (switching voltage 42V max.).
The board can be operated optionally with attached Raspberry Pi or always with a computer connected via the USB interface (Micro USB).
Both the inputs / outputs as well as the logic of the microcontroller are usable in both configurations.
The X1 board has a 9-24V wide-range DC voltage input with reverse polarity protection and has a 5V – 2.6 A voltage regulator with EMC protection circuit, which also takes the voltage supply of a mounted Raspberry Pi.

This Kit contains the dual channel RS232 interface shield. This interface can be controlled by the Raspberry Pi as well from the Arduino Controller.

For more details see here

Back to Hardware Shop